Difference between revisions of "Mesh/Network Configuration for Linux"
Jump to navigation
Jump to search
Redconfetti (talk | contribs) |
Redconfetti (talk | contribs) m (removed generic section) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
= | = Ubuntu = | ||
== | == GUI == | ||
* Click on the network icon on the top right of the toolbar. | * Click on the network icon on the top right of the toolbar. | ||
| Line 14: | Line 14: | ||
* Click Save | * Click Save | ||
* Click Close | * Click Close | ||
== Command Line == | |||
Ubuntu users can reconfigure their network settings using the command line. In a separate terminal you will log into the node using these directions: | |||
Find the name of your ethernet port by running <tt>ifconfig</tt> | |||
ifconfig | |||
In the example below, the wired Ethernet port was "eth0" | |||
In the terminal type the following, replacing "eth0" with the name of your Ethernet port: | |||
sudo ip addr add 172.22.0.9/24 dev eth0 | |||
Latest revision as of 20:36, 4 May 2016
Ubuntu
GUI
- Click on the network icon on the top right of the toolbar.
- Click "Edit connections..."
- Click on Ethernet connection "Wired connection 1" and click Edit
- Click on the "IPv4 Settings" tab
- Change method to "Manual"
- Click Add
- Under "Address" type the IP address
- Under "Netmask" type the Subnet Mask address
- Under "Gateway" type router / gateway address
- Click Save
- Click Close
Command Line
Ubuntu users can reconfigure their network settings using the command line. In a separate terminal you will log into the node using these directions:
Find the name of your ethernet port by running ifconfig
ifconfig
In the example below, the wired Ethernet port was "eth0"
In the terminal type the following, replacing "eth0" with the name of your Ethernet port:
sudo ip addr add 172.22.0.9/24 dev eth0