Difference between revisions of "Mesh/Flashing extender nodes"

no edit summary
Line 469: Line 469:
    
    
   root@sudomesh-node:/#
   root@sudomesh-node:/#
== Extender Node Installation ==
=== Installation Order ===
1. Flash home nodes and extender nodes
2. Get on roof and determine which direction to face the extender nodes
3. Install J-Pole
4. Crimp end onto Ethernet cable
5. Run Ethernet cable from j-pole down to location of home node (either through a soffit indoors or to an outdoor enclosure)
6. Crimp other end of Ethernet cable and connect to home node via a POE adaptor
7. Install extender node on J-Pole using zip-ties - check lights to make sure unit is powered up
8. Walk around the neighborhood to check the signal
=== Gear Checklist ===
* Protective and personal gear
* Wear clothes you can get dirty and sturdy boots for roof walking
* Sunscreen
* Sunglasses
* Pocketknife (for cutting zip ties etc)
* Ladder
* Safety harness & rope in a bucket
* Smart phone (to check signal and take pictures)
* Home node gear
* 2 flashed Western Digital Mynet N600 Home Nodes
* paperclip (to reset equipment)
* Laptop (to configure equipment)
* Plastic outdoor enclosure for router (optional)
* Power Strip
* J-Pole gear
* J-Pole
* Latex gloves (for dealing with roofing sealant)
* Roofing sealant
* Ratchet set - 10mm for small bolts, 13mm for large bolts
* Corldless Drill
* 3/16" drill bit for J-pole bolts
* Steel One-Hole Conduit Straps (for holding Ethernet cable along eves)
* Screws for the Steel one-hole straps
* Ethernet cable gear
* Ethernet Spool
* Ethernet Ends
* Ethernet Crimper
* Laminated card showing the Ethernet cable order
* Label Maker - so you can know which cable is which
* Extender node gear
* Flashed Ubiquiti Nanostation M2 or M5 extender Node(s)
* Power over Ethernet (POE) adapters
* Zip Ties
76

edits