Custom 3D Printer

This seems to be a custom 3D printer that was donated in the summer of 2023

• email thread

• Recently R came through and helped work on this with Avery, apparently it's a "VORON" 3d printer. Here are their notes:

Octopus pro 1.0
klipper via mainsail
connect via ip
127.0.0.1

Printer CFG is currrently a hack and slash from another voron config
!LOOK AT THE SENSOR SECTION, CHECK THE BED SENSOR AND PINS. SERIOUSLY. IT IS IMPORTANT.!

---

Forwarded message ----------

Date: Tue, 25 Jul 2023 21:39:31 -0700 From: Scott Griffitts Subject: Re: [sudo-info] 3D printer donation

Hey, Dropped off the printer with Toby and met a few folks who were excited, skeptical, and questioning the printer. I figured I would share some info on it.

Here is the page on the upgraded Z mod I did: https://seckit3dp.design/kit/triple-z

Here is the page for the main printer build: https://github.com/SecKit/SK-Go_SK-Mini

Here is some info on the firmware it can run: https://www.klipper3d.org/ (I think if you do some digging, you can find examples for the kinematic bed)

Here is the bed probe I used: https://coex3d.com/products/bltouch-v3-1-automatic-bed-leveling-probe

The stepper motor board used is big tree tech octopus v1.0 with TMC2209 drivers

If you have any other questions let me know :)

Also, If you guys need volunteers or anything, let me know. I’d love to help out with really cool people like you guys.

Regards Scott Griffitts