Difference between revisions of "3DPrinting"
| Line 22: | Line 22: | ||
* Print | * Print | ||
* Post-Print - remove from the 3D printer bed with a razor | * Post-Print - remove from the 3D printer bed with a razor | ||
== Gallery of Creations == | |||
<gallery widths="140px" heights="140px" perrow="4"> | |||
File:Raspberrypi3dprint.jpg | RaspBerry Pi print-out | |||
File:Sudoroom_photo.jpg | Our Office | |||
File:3dprintng.jpg | Creation | |||
File:Max3DPrinting.jpg | Today I Learned Class | |||
3D_Printed_Cigar_Rocket.jpg | 3D printed 2-part rocket. 65mm max diameter, 29mm motor bay, tangent ogive curve with internal 2-way structural ribs and support for airspeed sensor pitot tube at nose. | |||
</gallery> | |||
[[Category:Projects]] | |||
[[Category:3DPrinting]] | |||
= Older Documentation = | = Older Documentation = | ||
| Line 36: | Line 51: | ||
[[File:3D Printing Instructions Page 1.jpg|400px|3D Printing - page 1]] | [[File:3D Printing Instructions Page 1.jpg|400px|3D Printing - page 1]] | ||
Revision as of 22:43, 7 May 2013
Hardware
We currently have the following 3D printers:
Documentation
We currently don't have great documentation right now that covers turning on a printer, connecting it to the computer, calibration, and setting it up. We are working on that.
Overview
- Turn on the 3D Printer (switch is on the back right side)
- Make sure the 3D Printer is connected by USB to the desktop
- Start the program Repetier-Host http://www.repetier.com/documentation/repetier-host/
- Calibrate the printer
- Load your STL file (model of the 3D Printout)
- Slice the STL file into G-Code
- Post-Print - remove from the 3D printer bed with a razor
Gallery of Creations
RaspBerry Pi print-out
Our Office
Creation
Today I Learned Class
3D printed 2-part rocket. 65mm max diameter, 29mm motor bay, tangent ogive curve with internal 2-way structural ribs and support for airspeed sensor pitot tube at nose.
Older Documentation
Printer Calibration
Background: Original handwritten piece by Jae. This was the primary documentation for most of the early SudoRoom days and was writen down on a piece of paper. It's quite excellent.
Apocryphal Instructions page 1
Apocryphal Instructions page 2
Close up of an ancient hand-drawn diagram by our 3D printing shepherd, Jae
