Difference between revisions of "Network"
(→Addresses: brother printer) |
|||
Line 43: | Line 43: | ||
| Load balancer and reverse proxy (not yet in commission). | | Load balancer and reverse proxy (not yet in commission). | ||
| wrought | | wrought | ||
|- | |- | ||
| 192.168.42.8 | | 192.168.42.8 | ||
| | | | ||
| | | | ||
| | | the 3d printer desktop computer | ||
| [[User:Yar|yar]] | | [[User:Yar|yar]] | ||
|- | |- |
Revision as of 16:44, 5 September 2014
For more information about sudo room's systems in general, see Systems Administration
The sudo room network provides internal networking, internet access, wireless service, and some externally accessible devices or services. Information about the various devices in use and their configuration is available below.
peoplesopen.net
If you wish to connect to the local mesh network peoplesopen.net, then you can either connect using the peoplesopen.net wifi network, or you can connect using ethernet through the D-Link DIR-601A router on the shelf next to the main switch. Use DHCP to get a 10.0.0.0/8 IP address on the mesh network. The router will handle the meshing protocol for you and also provide you with normal Internet access.
Routing
Network Info
ExternalAddressesOur public IP is 142.254.24.227 InternalRanges
Addresses
Wireless Access Points
|