3DPrinting

From Sudo Room
Jump to navigation Jump to search
3dprinterfisheye02.jpg

Hardware

We currently have the following 3D printers:


Documentation

We currently don't have great documentation right now that covers turning on a printer, connecting it to the computer, calibration, and setting it up. We are working on that.

Overview

Quick and dirty overview

  • Turn on the 3D Printer (switch is on the back right side)
  • Make sure the 3D Printer is connected by USB to the desktop
  • Start the program Repetier-Host http://www.repetier.com/documentation/repetier-host/
  • Calibrate the printer
  • Load your STL file (model of the 3D Printout)
  • Slice the STL file into G-Code
  • Print
  • Post-Print - remove from the 3D printer bed with a razor

Gallery of Creations

Older Documentation

Printer Calibration

Background: Original handwritten piece by Jae. This was the primary documentation for most of the early SudoRoom days and was writen down on a piece of paper. It's quite excellent.

3D Printing - page 1