Hardware

Documentation

3D printers were a prophecy even in ancient times. Note the spool of red ABS plastic and the wise, jae-like figure teaching Sketchup.

Status

Status: Slowly piecing together documentation so that new people can get going. There are several key insruction pieces, but there is nothing that starts from the beginning and takes you to the end of turning on the 3D Printing desktop, clicking on the right software, calibrating the printer, and debugging. The status now is incomplete!

Overview

There are several steps in the 3D Printing process.

Hooking up the 3D Printer to a desktop or laptop computer. Unclear, needs to be written down
3D Modelling + 3D Printed Model Software (Google Sketchup, etc) - What we cover in our Today I Learned Workshops
Repetier-Host - open-source driver software connecting our computer with the 3D Printer
Printer Calibration (see comics) Only place where we have any documentation
Act of Printing
Caring of 3D Printed Objects + More How we remove the 3D Printed object from the printer bed, decorating the 3D Printed object, etc.

Printer Calibration

Background: Original handwritten piece by Jae. This was the primary documentation for most of the early SudoRoom days and was writen down on a piece of paper. It's quite excellent.

Apocryphal Instructions page 1
Apocryphal Instructions page 2
Close up of an ancient hand-drawn diagram by our 3D printing shepherd, Jae

Printer Calibration: Comics

A comic book interpretation of the Printer Calibration instructions from Jae.

Gallery of Creations

RaspBerry Pi print-out
Our Office
Creation
Today I Learned Class
3D printed 2-part rocket. 65mm max diameter, 29mm motor bay, tangent ogive curve with internal 2-way structural ribs and support for airspeed sensor pitot tube at nose.

3DPrinting

Contents