128
edits
Difference between revisions of "Mesh/Network Configuration for Linux"
Mesh/Network Configuration for Linux (view source)
Revision as of 20:36, 4 May 2016
, 20:36, 4 May 2016→Ubuntu: adding command line config instructions
Redconfetti (talk | contribs) |
Redconfetti (talk | contribs) (→Ubuntu: adding command line config instructions) |
||
| Line 1: | Line 1: | ||
== Generic == | == Generic == | ||
== | = Ubuntu = | ||
== GUI == | |||
* Click on the network icon on the top right of the toolbar. | * Click on the network icon on the top right of the toolbar. | ||
| Line 14: | Line 16: | ||
* Click Save | * Click Save | ||
* Click Close | * Click Close | ||
== Command Line == | |||
Ubuntu users can reconfigure their network settings using the command line. In a separate terminal you will log into the node using these directions: | |||
Find the name of your ethernet port by running <tt>ifconfig</tt> | |||
ifconfig | |||
In the example below, the wired Ethernet port was "eth0" | |||
In the terminal type the following, replacing "eth0" with the name of your Ethernet port: | |||
sudo ip addr add 172.22.0.9/24 dev eth0 | |||