625
edits
Difference between revisions of "Mesh/WalkThrough"
→Configure your computer's network settings: add <code> formatting
(→Configure your computer's network settings: add <code> formatting) |
|||
| Line 77: | Line 77: | ||
* Network Manager Method: Manual | * Network Manager Method: Manual | ||
* IP Address: 192.168.1.10 (some devices will only accept from this IP) | * IP Address: <code>192.168.1.10</code> (some devices will only accept from this IP) | ||
* Subnet Mask: 255.255.255.0 | * Subnet Mask: <code>255.255.255.0</code> | ||
* Gateway: 0.0.0.0 (Or leave blank) | * Gateway: <code>0.0.0.0</code> (Or leave blank) | ||
You can also use the commands: | You can also use the commands: | ||
| Line 86: | Line 86: | ||
sudo ip link set <eth_interface> up | sudo ip link set <eth_interface> up | ||
where <eth_interface> is the name of your ethernet interface found using | where <code><eth_interface></code> is the name of your ethernet interface found using <code>ip addr</code> (common names include <code>eth0</code>, <code>enp3s0</code>, ...) | ||
See Network Configuration Guides: [[Mesh/Network%20Configuration%20for%20Linux | Linux]], [[Mesh/Network%20Configuration%20for%20MacOS%20X | Mac]] | See Network Configuration Guides: [[Mesh/Network%20Configuration%20for%20Linux | Linux]], [[Mesh/Network%20Configuration%20for%20MacOS%20X | Mac]] | ||