Sudo Room

Difference between revisions of "Mesh/WalkThrough"

Mesh/WalkThrough (view source)

Revision as of 22:06, 13 November 2019

648 bytes removed ,  22:06, 13 November 2019
cleans up ending
(cleans up ending)
Line 164: Line 164:
     passwd admin
     passwd admin


== Makenode (v.0.2.3 and earlier) ==
== Testing ==
'''''Note: If you installed autoconfiguring [https://github.com/sudomesh/sudowrt-firmware/releases/tag/0.3.0 release 0.3.0] for myNet N600 routers, you do not need to use makenode. See the autoconf instructions above.'''''
 
Makenode's documentation has been consolidated to [[Mesh/Makenode|its page.]]
 
= Testing =


After you're finished with the flashing and configuration, your home node should be available for connections via your private WiFi SSID. Additionally the public SSID 'peoplesopen.net' will be available. It should also be populated on the [https://peoplesopen.herokuapp.com monitor]!
After you're finished with the flashing and configuration, your home node should be available for connections via your private WiFi SSID. Additionally the public SSID 'peoplesopen.net' will be available. It should also be populated on the [https://peoplesopen.herokuapp.com monitor]!
Line 175: Line 170:
A third interface named 'pplsopen.net-node2node' will be detectable as well. This is the interface used for the nodes to mesh with each other.
A third interface named 'pplsopen.net-node2node' will be detectable as well. This is the interface used for the nodes to mesh with each other.


At this point you're setup. For more information on using your node, such as accessing the web-based management interface, see [[Home and extender nodes#Home_nodes|Home node info]]
At this point you're setup. Reach out to the [[Mesh#How_To_Participate|rest of the network]]!


For more technical details on the internals of the home node, see the [[Mesh/Technical_Overview]]
== Makenode (v.0.2.3 and earlier) ==
'''''Note: If you installed autoconfiguring [https://github.com/sudomesh/sudowrt-firmware/releases/tag/0.3.0 release 0.3.0] for myNet N600 routers, you do not need to use makenode. See the autoconf instructions above.'''''


For more in depth testing procedures, see our [https://github.com/sudomesh/babeld-lab/blob/master/operator_manual.md mesh node operator's manual].
Makenode's documentation has been consolidated to [[Mesh/Makenode|its page.]]
 
= Troubleshooting =
If you get the error "no such file or directory", open a new terminal and run this command to ensure that <tt>node</tt> points to your NodeJS executable:
 
  sudo ln -s nodejs node
 
In the new terminal, return to the 'makenode' source code directory and try again:
 
  npm install
  ./makenode.js


= Flashing TP-Link Routers =
= Flashing TP-Link Routers =
Retrieved from "https://sudoroom.org/wiki/Special:MobileDiff/11654"