56
edits
Difference between revisions of "3DPrinting"
Adding a photo
Rabbitface (talk | contribs) (Adding a photo) |
|||
| Line 1: | Line 1: | ||
[[File:3dprinterfisheye02.jpg|thumb]] | |||
== [[3DPrintingEvents|3D Printing Events]] == | == [[3DPrintingEvents|3D Printing Events]] == | ||
* April 20. 2013 - [[Just enough sketchup to pretend you can 3d model II & Just enough slic3r to pretend you can extrude I]] | * April 20. 2013 - [[Just enough sketchup to pretend you can 3d model II & Just enough slic3r to pretend you can extrude I]] | ||
== Mentoring in 3D Printing == | == Mentoring in 3D Printing == | ||
| Line 10: | Line 11: | ||
==Hardware== | ==Hardware== | ||
We have a Type A 3D Printer. | We have a Type A 3D Printer. | ||
== Documentation == | == Documentation == | ||
[[File:JaySavior3Dprinting.jpg|400px|thumb|right|3D printers were a prophecy even in ancient times. Note the spool of red ABS plastic and the wise, jay-like figure teaching Sketchup.]] | |||
There's an apocryphal sheet of paper with the perfect set of instructions. | There's an apocryphal sheet of paper with the perfect set of instructions. | ||
| Line 49: | Line 52: | ||
* Tip 3 - After "homing" z, manually adjusting z by 0.1 mm should cause a visible gap between the nozzle & print bed. | * Tip 3 - After "homing" z, manually adjusting z by 0.1 mm should cause a visible gap between the nozzle & print bed. | ||
= Gallery of Creations = | == Gallery of Creations == | ||
<gallery widths="140px" heights="140px" perrow="4"> | <gallery widths="140px" heights="140px" perrow="4"> | ||