Difference between revisions of "3DPrinting"

Jump to navigation Jump to search
42 bytes added ,  18:16, 20 April 2013
Adding a photo
(Adding a photo)
Line 1: Line 1:
[[File:3dprinterfisheye02.jpg|thumb]]
== [[3DPrintingEvents|3D Printing Events]] ==
== [[3DPrintingEvents|3D Printing Events]] ==
* April 20. 2013 - [[Just enough sketchup to pretend you can 3d model II & Just enough slic3r to pretend you can extrude I]]
* April 20. 2013 - [[Just enough sketchup to pretend you can 3d model II & Just enough slic3r to pretend you can extrude I]]


== Mentoring in 3D Printing ==
== Mentoring in 3D Printing ==
Line 10: Line 11:


==Hardware==
==Hardware==
[[File:JaySavior3Dprinting.jpg|400px|thumb|right|3D printers were a prophecy even in ancient times. Note the spool of red ABS plastic and the wise, jay-like figure teaching Sketchup.]]
 
We have a Type A 3D Printer.
We have a Type A 3D Printer.


== Documentation ==
== Documentation ==
[[File:JaySavior3Dprinting.jpg|400px|thumb|right|3D printers were a prophecy even in ancient times. Note the spool of red ABS plastic and the wise, jay-like figure teaching Sketchup.]]


There's an apocryphal sheet of paper with the perfect set of instructions.
There's an apocryphal sheet of paper with the perfect set of instructions.
Line 49: Line 52:
* Tip 3 - After "homing" z, manually adjusting z by 0.1 mm should cause a visible gap between the nozzle & print bed.
* Tip 3 - After "homing" z, manually adjusting z by 0.1 mm should cause a visible gap between the nozzle & print bed.


= Gallery of Creations =
== Gallery of Creations ==


<gallery widths="140px" heights="140px" perrow="4">
<gallery widths="140px" heights="140px" perrow="4">

Navigation menu