3D Printing Events




Hardware

We have a Type A 3D Printer.

Documentation

There's an apocryphal sheet of paper with the perfect set of instructions. It was left by the Early Ones, the Savior Jay. We keep an electronic copy of the original on the Wiki but all new followers should read and reread the UrText in person, accompanied by a SudoRoom mentor.

Adjusting the Print Beds

  • Do not put multiple layers of tape on the glass print-bed: this makes the print-bed less "sticky"

Use the "manual control" in Repetier-Host to

  • "Home" the Z (height) by clicking on the Home-Z
    • This will move the bed up until ?? switch cliks
    • the Z-Switch is pushed by a knob attached to the print bed. If you rotate the knob, it will adjust the global z-height of the print-bed
  • Ensure the print nozzle is not touching the tape by pressing Z+ (move the bed down)
  • "Home" the X & Y by clicking on HomeX and Home?
  • Move the print head around, especially near the [holy scriptures erased] corners of the bed
  • Turn the paper over
  • Use the allen key on the 4 corner screws to ensure that all four corners are equally far away from the print Nozzle.
  • Tip 1: Adjust the Z manually until a piece of paper barely fits under the nozzle. Friction will tell you how big the gap is...
  • Tip 2: don't scratch the tape on the print bed!
  • Tip 3: There are 4 screws, but only 3 free degrees of motion since the bed is FLAT. So this part is TRICKY. Be patient!
  • When satisfied, consider adjusting that global Z-height by turning the knob.
  • Tip 1 - the knob is not tight, so secure it with the tape so it doesn't accidentally rotate.
  • Tip 2- You want the gap to be exactly 0 zero after "homing" the Zaxis
  • Tip 3 - After "homing" z, manually adjusting z by 0.1 mm should cause a visible gap between the nozzle & print bed.

Gallery of Creations