Difference between revisions of "Mesh/Network Configuration for Linux"

→‎Ubuntu: adding command line config instructions
(→‎Ubuntu: adding command line config instructions)
Line 1: Line 1:
== Generic ==
== Generic ==


== Ubuntu ==
= Ubuntu =
 
== GUI ==


* Click on the network icon on the top right of the toolbar.
* Click on the network icon on the top right of the toolbar.
Line 14: Line 16:
* Click Save
* Click Save
* Click Close
* Click Close
== Command Line ==
Ubuntu users can reconfigure their network settings using the command line. In a separate terminal you will log into the node using these directions:
Find the name of your ethernet port by running <tt>ifconfig</tt>
  ifconfig
In the example below, the wired Ethernet port was "eth0"
In the terminal type the following, replacing "eth0" with the name of your Ethernet port:
  sudo ip addr add 172.22.0.9/24 dev eth0
128

edits