128
edits
Difference between revisions of "Mesh/WalkThrough"
Jump to navigation
Jump to search
m
fixed formatting of
Redconfetti (talk | contribs) |
Redconfetti (talk | contribs) m (fixed formatting of) |
||
| Line 63: | Line 63: | ||
* Click Browse and select the firmware you downloaded | * Click Browse and select the firmware you downloaded | ||
* Click Install | * Click Install | ||
** Sometimes the interface will hang. You should get a page with a countdown of 120+ seconds. If this does not occur, reboot the router with the pin reset button depressed (as noted above), and try again. | |||
= Configuring Your OpenWRT Router to Work on the Sudomesh Network = | = Configuring Your OpenWRT Router to Work on the Sudomesh Network = | ||
| Line 78: | Line 78: | ||
The default settings in `settings.js` should suffice in most cases, but if you need to make changes, do them in 'settings.js'. | The default settings in `settings.js` should suffice in most cases, but if you need to make changes, do them in 'settings.js'. | ||
A freshly flashed node will be setup on 172.22.0.1, so you will need to configure your machine to use IP address 172.22.0.9 (subnet 255.255.255.0, gateway: 0.0.0.0). | A freshly flashed node will be setup on 172.22.0.1, so you will need to configure your machine to use IP address 172.22.0.9 (subnet 255.255.255.0, gateway: 0.0.0.0). On your laptop (instructions for Ubuntu) edit your network settings by doing the following: | ||
On your laptop (instructions for Ubuntu) edit your network settings by doing the following: | |||
Click on the network icon on the top right of the toolbar. | Click on the network icon on the top right of the toolbar. | ||
| Line 92: | Line 91: | ||
Click Save | Click Save | ||
Click Close | Click Close | ||
If you are using a Mac and configuring the network settings, you may need to simply leave the "Gateway" setting blank when configuring your network settings. | |||
Make sure the ethernet cable is connected to the 4th port on the router (closest to the yellow internet port). | Make sure the ethernet cable is connected to the 4th port on the router (closest to the yellow internet port). | ||