Difference between revisions of "TAZ"

← Older edit

TAZ (view source)

Revision as of 13:30, 15 June 2022

621 bytes added , 13:30, 15 June 2022

no edit summary

Jerkey

Bureaucrats, Interface administrators, Administrators, Widget editors

335

edits

@@ Line 1: / Line 1: @@
 [[File:Taz_first_print_2.jpg|right|frameless|460px]]
+UPDATE: Sudoroom acquired a [[TAZ_4|TAZ4]] in 2022 and [[user:Jerkey]] swapped the extruder out of the TAZ3 onto it, since the TAZ3 would not do a decent print and the TAZ4 looked good but was missing an exturder.  The TAZ3 will be converted to [https://github.com/hzeller/rpt2pnp solder paste dispensing] only, as seen [https://hackaday.com/2014/04/02/dispensing-solder-paste-with-a-3d-printer/ here on Hackaday]
 Sudoroom has a [https://www.lulzbot.com/products/lulzbot-taz-3-3d-printer TAZ3] 3D printer. We won it in the [https://www.lulzbot.com/ LulzBot] 2014 printer giveaway! It can print from an SD card, with many materials:
@@ Line 15: / Line 17: @@
 * [https://download.lulzbot.com/TAZ/3.0/documentation/2013Q4/LulzBot_TAZ_3.0-User_Manual-ebook.pdf TAZ 3.0 User Manual PDF]
-=== SetUp ===
+=== Hardware ===
+* [https://reprap.org/wiki/File:Rambo1-2-conn-main.jpg  diagram of RAMBO control board]
 === Firmware ===
@@ Line 21: / Line 25: @@
 https://github.com/sudoroom/taz3d
-if you screw up the firmware with a weird upload or whatever, here's the factory hex file (which can be flashed using cura-lulzbot)
+Below are links to the original firmware from the manufacturer's site, AKA the first commits in the above GitHub repo.
+here's the factory hex file (which can be flashed using cura-lulzbot)
 https://devel.lulzbot.com/TAZ/3.1/software/2014Q2/firmware/marlin/Marlin_taz3.1.cpp.hex
-source:
+factory firmware source code (Marlin with configuration tweaks):
 http://download.lulzbot.com/TAZ/3.1/software/current/firmware/marlin_taz/marlin_taz.tar.bz2