Difference between revisions of "Mesh/WalkThrough"

Mesh/WalkThrough (view source)

612 bytes removed , 18:45, 23 June 2018

36

edits

@@ Line 80: / Line 80: @@
 Note: Sometimes the firmware upload will not complete. After you click on 'Upload' You should get a page with a countdown of 120+ seconds. If this does not occur, reboot the router with the pin reset button depressed (as noted above), and try again.
-= Notice for (MyNet N600 only) Release 0.3.0 =
-[https://github.com/sudomesh/sudowrt-firmware/releases/tag/0.3.0/ Release 0.3.0 (dispossessed)] allows a newly flashed node to retrieve an IP over its WAN connection from a [https://github.com/sudomesh/meshnode-database sudomesh/meshnode-database]. Once the node gets an IP, it configures itself to mesh with other People's Open Nodes and tunnel to a [https://github.com/sudomesh/exitnode sudomesh/exitnode]. makenode/Configure is no longer required & you are done installing the firmware. [https://github.com/sudomesh/sudowrt-firmware/pull/132 More information.]
 = makenode/Configure =