Bureaucrats, oversight, Administrators
1,196
edits
Difference between revisions of "Mesh/WalkThrough"
Jump to navigation
Jump to search
updated node ports image
Tunabananas (talk | contribs) m |
Tunabananas (talk | contribs) (updated node ports image) |
||
| Line 106: | Line 106: | ||
'''''Note: If you installed autoconfiguring [https://github.com/sudomesh/sudowrt-firmware/releases/tag/0.3.0 release 0.3.0] for myNet N600 routers, you will not need to use makenode ([[#Makenode_.28v.0.2.3_and_earlier.29|instructions further down]]) after flashing the sudowrt-firmware to your router to configure it to work on People's Open Network.''''' | '''''Note: If you installed autoconfiguring [https://github.com/sudomesh/sudowrt-firmware/releases/tag/0.3.0 release 0.3.0] for myNet N600 routers, you will not need to use makenode ([[#Makenode_.28v.0.2.3_and_earlier.29|instructions further down]]) after flashing the sudowrt-firmware to your router to configure it to work on People's Open Network.''''' | ||
[[File:Nodeports. | [[File:Nodeports titles.png|400px|thumb|right|Plug into port 3 to access the private network from your laptop. Port 2 connects to the public 'peoplesopen.net' network]] Connect your newly-flashed MyNet N600 to your existing Internet router via ethernet from your existing router's LAN port to your new node's Internet port. Wait a few minutes for your new node to connect to the Internet and obtain its private IP address, then try connecting to your unconfigured router by opening a browser and navigating to http://172.30.0.1 | ||
If the flash was successful you should be brought to the following screen: | If the flash was successful you should be brought to the following screen: | ||