Jump to navigation Jump to search
224 bytes added ,  14:48, 9 December 2018
Add flag to Makenode section warning away Autoconf users.
== Makenode (v.0.2.3 and earlier) ==
'''''Note: If you installed autoconfiguring [ release 0.3.0] for myNet N600 routers, you do not need to use makenode. See the autoconf instructions above.'''''
After you have successfully flashed your router with OpenWRT, you will need to use [ makenode] to complete the setup. makenode registers your node on the peoplesopen network, resulting in the assignment of a 64 IPv4 address subnet to your node, in addition to applying basic configuration.

Navigation menu