Difference between revisions of "Big red laser cutter"

Jump to navigation Jump to search
no edit summary
Line 6: Line 6:


Some of the software (downloaded from the above link) is on the hard drive of wasp.local which is a desktop computer under the 3D printer desk, in a folder called ~/laser-backup/
Some of the software (downloaded from the above link) is on the hard drive of wasp.local which is a desktop computer under the 3D printer desk, in a folder called ~/laser-backup/
[https://spaz.org/~jake/sudoroom/Big_red_laser_cutter/ <u>The above software has also been downloaded and stored here</u>]


it was setup with an IP address of 100.64.64.69 (by pressing buttons through the menu) but it had no ports open and then we just switched over to USB to the computer and it was working fine.  The same software might work over ethernet but we didn't try.
it was setup with an IP address of 100.64.64.69 (by pressing buttons through the menu) but it had no ports open and then we just switched over to USB to the computer and it was working fine.  The same software might work over ethernet but we didn't try.

Navigation menu