289
edits
Difference between revisions of "Big red laser cutter"
Jump to navigation
Jump to search
no edit summary
Andrewrgross (talk | contribs) |
|||
| Line 1: | Line 1: | ||
=== info about our hardware === | |||
The big red laser cutter in sudo room is some no-name model. It uses a Ruida 644XG control board and LightBurn can speak to it (we were running LightBurn 0.9.24 earlier but the 30 day trial expired). | The big red laser cutter in sudo room is some no-name model. It uses a Ruida 644XG control board and LightBurn can speak to it (we were running LightBurn 0.9.24 earlier but the 30 day trial expired). | ||
| Line 4: | Line 6: | ||
The Melbourne Makerspace has the same laser and have a [https://wiki.melbournemakerspace.org/Laser%20Cutter nicely written wiki page on it]. | The Melbourne Makerspace has the same laser and have a [https://wiki.melbournemakerspace.org/Laser%20Cutter nicely written wiki page on it]. | ||
=== how to use it === | |||
Open Lightburn (comes with a one-time free 30-day trial period) and get to cutting. We are planning to buy a copy for the desktop computer next to the laser cutter, but until then feel free to use up your 30-day trial on your laptop. Or get one of the other (free) pieces of software to work: | |||
=== other software === | |||
As mentioned, RDWorks can also be used. We haven't tried it yet but it seems it's a free download [https://www.thunderlaser.com/laser-download from here]. | As mentioned, RDWorks can also be used. We haven't tried it yet but it seems it's a free download [https://www.thunderlaser.com/laser-download from here]. | ||
| Line 13: | Line 21: | ||
it was setup with an IP address of 100.64.64.69 (by pressing buttons through the menu) but it had no ports open and then we just switched over to USB to the computer and it was working fine. The same software might work over ethernet but we didn't try. | it was setup with an IP address of 100.64.64.69 (by pressing buttons through the menu) but it had no ports open and then we just switched over to USB to the computer and it was working fine. The same software might work over ethernet but we didn't try. | ||
=== | === Trying other things === | ||
Andy is trying to find software to control the laser cutter. I can generate gcode instructions in Inkscape, but I don't know how to send them to the printer over USB. | Andy is trying to find software to control the laser cutter. I can generate gcode instructions in Inkscape, but I don't know how to send them to the printer over USB. | ||