348
edits
Difference between revisions of "Custom 3D Printer"
Jump to navigation
Jump to search
no edit summary
| Line 3: | Line 3: | ||
* [https://sudoroom.org/lists/hyperkitty/list/sudo-discuss@sudoroom.org/thread/Y2T3YOU5OBPD3U6DMMOKJ3CFRCLO6SLR/ email thread] | * [https://sudoroom.org/lists/hyperkitty/list/sudo-discuss@sudoroom.org/thread/Y2T3YOU5OBPD3U6DMMOKJ3CFRCLO6SLR/ email thread] | ||
* Recently R came through and helped work on this with Avery, apparently it's a "VORON" 3d printer. Here are their notes:<code> | |||
Octopus pro 1.0 | |||
klipper via mainsail | |||
connect via ip | |||
127.0.0.1 | |||
Printer CFG is currrently a hack and slash from another voron config | |||
!LOOK AT THE SENSOR SECTION, CHECK THE BED SENSOR AND PINS. SERIOUSLY. IT IS IMPORTANT.!</code> | |||
---------- Forwarded message ---------- | ---------- Forwarded message ---------- | ||