7
edits
(→Status) |
m |
||
Line 18: | Line 18: | ||
* The nozzle should be just a millimeter or so above the bed. '''Tip:''' wiggle a piece of paper under it - heavy friction means a little too close. | * The nozzle should be just a millimeter or so above the bed. '''Tip:''' wiggle a piece of paper under it - heavy friction means a little too close. | ||
* We need more ScotchBlue #2093EL tape. | * We need more ScotchBlue #2093EL tape. | ||
==Extruder Hot End== | |||
Our extruder is has a 12v cartridge heater and .35mm nozzle. This is standard for extruding a 1.75mm PLA filament. | |||
Type A is routinely out of stock, but replacement kits can be found here: http://www.makergear.com/products/extruders | |||
[[File:ExtruderWiring.jpg|thumb|Wiring configuration for Series 1 Typa 3d Printer: Orange to Green; Purple to Clear; Red/Black to Red/Black]] | |||
==Attached Computer== | ==Attached Computer== |
edits