|
|
Line 545: |
Line 545: |
| | | |
| root@sudomesh-node:/# | | root@sudomesh-node:/# |
|
| |
| == Extender Node Installation ==
| |
| === Installation Order ===
| |
| #Flash home nodes and extender nodes
| |
| #Get on roof and determine which direction to face the extender nodes
| |
| #Install J-Pole
| |
| #Crimp end onto Ethernet cable
| |
| #Run Ethernet cable from j-pole down to location of home node (either through a soffit indoors or to an outdoor enclosure)
| |
| #Crimp other end of Ethernet cable and connect to home node via a POE adaptor
| |
| #Install extender node on J-Pole using zip-ties - check lights to make sure unit is powered up
| |
| #Walk around the neighborhood to check the signal
| |
|
| |
| === Gear Checklist ===
| |
|
| |
| Protective and personal gear
| |
| *Wear clothes you can get dirty and sturdy boots for roof walking
| |
| *Sunscreen
| |
| *Sunglasses
| |
| *Pocketknife (for cutting zip ties etc)
| |
| *Ladder
| |
| *Safety harness & rope in a bucket
| |
| *Smart phone (to check signal and take pictures)
| |
| Home node gear
| |
| *2 flashed Western Digital Mynet N600 Home Nodes
| |
| *paperclip (to reset equipment)
| |
| *Laptop (to configure equipment)
| |
| *Plastic outdoor enclosure for router (optional)
| |
| *Power Strip
| |
| J-Pole gear
| |
| *J-Pole
| |
| *Latex gloves (for dealing with roofing sealant)
| |
| *Roofing sealant
| |
| *Ratchet set - 10mm for small bolts, 13mm for large bolts
| |
| *Corldless Drill
| |
| *3/16" drill bit for J-pole bolts
| |
| *Steel One-Hole Conduit Straps (for holding Ethernet cable along eves)
| |
| *Screws for the Steel one-hole straps
| |
| Ethernet cable gear
| |
| *Ethernet Spool
| |
| *Ethernet Ends
| |
| *Ethernet Crimper
| |
| *Laminated card showing the Ethernet cable order
| |
| *Label Maker - so you can know which cable is which
| |
| Extender node gear
| |
| *Flashed Ubiquiti Nanostation M2 or M5 extender Node(s)
| |
| *Power over Ethernet (POE) adapters
| |
| *Zip Ties
| |