Difference between revisions of "Mesh/OpenWRT"

Jump to navigation Jump to search
192 bytes added ,  18:30, 17 June 2013
Line 279: Line 279:
  received ACK <block=13468>
  received ACK <block=13468>


Once those lines stop coming the router will take a minute, then reboot. Do not turn unplug / turn off the router for at couple of minutes after flashing.
Once those lines stop coming the router will take somewhere between 1 and 7 minues to stop flashing its lights at you, then it will reboot. DO NOT unplug or turn off the router until it presents two adjacent green LEDs and has done so for 10+ seconds. On the older routers the upgrade can take much longer than on the newer routers so be patient.


Note, that if you're flashing AirOS instead, at least the Bullet M5 series will remember setting between firmware upgrades and others may do so too. To reset username / password / ip address and other settings to factory default, first let the router boot, then press and holde the reset button until more lights come on and release. Wait for the factory reset to complete (a minute or two) and try to access 192.168.1.1 in a browser (ensure that your own ip is in the 192.168.1.x range). Note: This procedure seems to have no effect on the Bullet 2 HP, but works on the Bullet M5. It could be that the Bullet 2 HP does not persist settings across firmware upgrades, and so doesn't have the factory reset procedure.
Note, that if you're flashing AirOS instead, at least the Bullet M5 series will remember setting between firmware upgrades and others may do so too. To reset username / password / ip address and other settings to factory default, first let the router boot, then press and holde the reset button until more lights come on and release. Wait for the factory reset to complete (a minute or two) and try to access 192.168.1.1 in a browser (ensure that your own ip is in the 192.168.1.x range). Note: This procedure seems to have no effect on the Bullet 2 HP, but works on the Bullet M5. It could be that the Bullet 2 HP does not persist settings across firmware upgrades, and so doesn't have the factory reset procedure.

Navigation menu