My IP on pullwax is 172.30.0.174/24. I don't understand your solution -
both SSID (pullwax and
peoplesopen.net) are from the same device, so
there is no way to install a router between the networks. Besides, I
don't really need a temp solution, it's not an issue for me if it
doesn't work - just wanted to let you know for troubleshooting of the
firmware. Have you experienced this issue in the other nodes?
On 04/05/2014 12:04 PM, Somebody wrote:
Just out of curiosity, is the private network on the
10.?
If so, perhaps a temporary solution could be to install a router between the two 10.
Networks.
Scott Olsen <scott(a)veteranstechcollective.org> wrote:
> Hi folks,
> I just installed the node you lent me (14th Ave/E 27th). The private
> network (SSID: pullwax) works great: I can connect to it, access the
> internet, and log into the router admin interface. The
peoplesopen.net
> SSID is a different story. DNS resolution works and traffic (ping)
> directly to the router works, but that's about all. I cannot access or
> ping any internet hosts. My device is assigned an IP (10.0.26.201) and I
> can ping the router at 10.42.10.10. Traceroute to internet hosts do not
> even bounce off of the gateway 10.42.10.10. I think I'm at the end of my
> ability to troubleshoot this issue further with my current knowledge of
> the mesh system, just wanted to give yall a heads up.
> Scott
>
>
>
> _______________________________________________
> mesh mailing list
> mesh(a)lists.sudoroom.org
>
https://lists.sudoroom.org/listinfo/mesh