New subject: We need access to our router/AP

29 May 2013

On Tue, May 28, 2013 at 8:24 AM, Matthew Meier &lt;wolfy(a)wlfy.it&gt; wrote:
...
  The modem should be provided by the ISP and
shouldn't require any config
 minus occasionally needing to disable the built in firewall. The Pix Device
 is the Firewall and Router. You only need to mess with firewall settings
 with mucking about with the port forwards. The rules in the firewall
 reference the "Outward facing Interface" so their IP information should
 adjust once the IP settings are changed. 
So, I've followed all your instructions - we are on the exact same
subnet with the same default route, so all I had to change was our
static IP. I also noticed that the firewall rules referred to
"TheInternet-Interface" which still had our old IP, so I changed that
too. Right now we have connectivity through LMI, but it is relatively
slow, and there is a bizarrely recurring service outage of exactly 1
minute every 3 minutes, so no connectivity at these times:

   2:39:38 until 2:40:38
   2:42:38 until 2:43:38
   ......
   3:09:38 until 3:10:48

... and so on.

I don't know enough about this machine to troubleshoot a whole lot.
I'm not even sure how to reboot it...

Re: [sudo-sys] We need access to our router/AP