28 Jul
2019
28 Jul
'19
10:52 p.m.
No I have not used distilled water. I will pick some up later this week.
Thank you for the advice.
Robert Albert Young Chu
P::415-724-0425
E:: robert.chu01(a)gmail.com
On Sun, Jul 28, 2019 at 9:21 PM Marc Juul <marc(a)juul.io> wrote:
On 7/28/19, Robert Chu <robert.chu01(a)gmail.com>
wrote:
Hello Sudo room I went through the laser cutter
system and environment
thoroughly, and we are now able to use it at 24/7.
Niice!
there are a couple of loose connections inside
that I solded alligator
clips to to clip onto the laser itself.
I replaced the 4-ft water pump hoses with 6'1 so that there's slack with
the laser system and water canister.
I cleaned out the water canister a bit and replaced the water.
Great! You used distilled/demineralized water right?
Ripped out all the old tape that partially
covered some of the gaps in
the
ventilation system. I'd redone it thoroughly
with new foil tape.
I have truncated all excess hosing on the short ventilation run for
better
air flow. I also compressed all of the excess
hosing on the larger run
for
better airflow as well. All of the slack has been
removed from both
sides.
I ventilation leak test by engaging the laser into a thick piece of wood
for about 30 seconds, which has also cause flames to be admitted from it
while firing. The test has passed as their husband no smell of of smoke
inside Sudo To with it on for that period of time.
I am full of excitement, ambition, joy, and hackery, to let everybody
know
that our MLE-40 laser system is back online. it
hasn't been too long
because it hasn't been done again until now.
Looking forward to playing with it!
--
marc/juul