27 Jan
2015
27 Jan
'15
9:03 a.m.
The 3d printer area run still has not been installed. I don't think GFIs
are the solution, additional breakers and outlets are. I can come by to
meet with you wednesday early evening. But practically speaking the room
only has one breaker assigned to it. The server area has designated
breakers, the robot has one for itself, and then the peripheral plugs are
on another. So a busy space with many people working on computers plus a
motor or other high inductive load is not difficult to imagine.
The reason I'd like to meet is to know exactly which breaker tripped. I
presume the one I describe above.
-Whit
On Mon, Jan 26, 2015 at 10:36 PM, <hol(a)gaskill.com> wrote:
which breaker? probably just too many amps. the
second run to the 3d
printing area - did that get installed?
On 2015-01-26 21:48, Jake wrote:
GFI's are totally seperate from circuit
breakers.
they would not reduce the incidence of circuit breaker tripping.
old, defective circuit breakers sometimes trip at lower current than
they are supposed to. if it happens again we should figure out what
the problem is.
-jake
On Mon, 26 Jan 2015, David Keenan wrote:
Hey all,
Someone was experimenting with electrical stuff
and tripped breakers...
I think Sudo's standard outlets should be rewired with GFI outlets if
this will cut down on this happening -
I will volunteer to replace these with one other who knows electrical
(Whitney? Jake?) if it can be budgeted.
Is this agreeable to folks?
_______________________________________________
sudo-discuss mailing list
sudo-discuss(a)lists.sudoroom.org
https://lists.sudoroom.org/listinfo/sudo-discuss