23 Apr
2013
23 Apr
'13
6:58 p.m.
Ohhh Ground! That would explain why we keep baking our pis
On Apr 23, 2013 6:55 PM, "Jae Kwon" <jkwon.work(a)gmail.com> wrote:
Just found this thread...
The pins are for serial connections. the USB is just for power.
(the strange setup is due to the fact that I found out that USB doesn't
work with long cables, after I set up the USB)
The doorman.py script uses ttyAMA0 to communicate to the MSP430. So, the
two pins that were knocked off, should have gone to GRN and UART-TX (serial
UART transmit pin), wherever those are.
On Fri, Mar 22, 2013 at 9:56 AM, Andrew <andrew(a)roshambomedia.com> wrote:
I'm confused actually. why where there pins
on the raspi being used at
all? the serial connection is usb, what else needs to go to the MSP430,
power?
https://gitorious.org/doorman/doorman
On Fri, Mar 22, 2013 at 9:52 AM, <hol(a)gaskill.com> wrote:
also, i looked into the internal oscillator on
the arduino (ATmega328P)
and it should work for I2C or analog stuff but might have difficulty with
TTL serial based on factory tolerances
http://electronics.stackexchange.com/questions/27763/using-the-atmega328-wi…
--
---------
Andrew Lowe
http://www.lostways.com
_______________________________________________
sudo-discuss mailing list
sudo-discuss(a)lists.sudoroom.org
http://lists.sudoroom.org/listinfo/sudo-discuss