14 Jan
2015
14 Jan
'15
8:38 a.m.
While it's not ZIF, I have an AVRISP in my drawers of random
electronics stuff over by the tek equipment. A ZIF socket could be
picked up at HSC or Al lasher's rather quickly.
---
Aperture Systems: Redefining Radiography - http://aperture.systems/
http://adammunich.com/ - Cell: +1-650-452-0554
Be • knowledgeable • social • patient • fearless • compassionate •
fun • humble • forgiving.
Be a leader
On Tue, Jan 13, 2015 at 9:47 PM, Mitch Altman <maltman23(a)hotmail.com> wrote:
I program 100 to 500 AVR chips (of various flavors) at
a setting for my
kits. All DIP. I only use a regular DIP socket and a USBtinyISP. I bend
the legs while one is already programming. I insert the chip only halfway
into the DIP socket. I think this is actually easier than using a ZIF
socket -- no need to push and pull that little handle.
Mitch.
Date: Tue, 13 Jan 2015 18:46:00 -0800
From: pp(a)myelin.co.nz
To: pdbogen(a)cernu.us
CC: jake(a)spaz.org; sudo-discuss(a)lists.sudoroom.org;
noisebridge-discuss(a)lists.noisebridge.net; adi(a)hexapodia.org
Subject: Re: [Noisebridge-discuss] looking for a ZIF socket programmer for
atmega328p atmel chips
Jake - what package are you looking at? The atmega328p-pu DIP, the
atmega328p-au TQFP, or one of the more complicated ones?
Is this for production programming? If it's for dev, can you program
it in-circuit instead?
Cheers,
Phil
On Tue, Jan 13, 2015 at 5:58 PM, <pdbogen(a)cernu.us> wrote:
_______________________________________________
sudo-discuss mailing list
sudo-discuss(a)lists.sudoroom.org
https://lists.sudoroom.org/listinfo/sudo-discuss
You can program them from a serial port as well,
albeit very slowly.
It's a
pretty cool hack:
http://avrprogrammers.com/programmers/all-serial-port
- Patrick
On Tue, Jan 13, 2015 at 05:50:04PM -0800, Andy Isaacson wrote:
_______________________________________________
Noisebridge-discuss mailing list
Noisebridge-discuss(a)lists.noisebridge.net
https://www.noisebridge.net/mailman/listinfo/noisebridge-discuss On Tue, Jan 13, 2015 at 05:46:39PM -0800, Jake
wrote:
> i looked on ebay but couldn't find anything cheap.
>
> isn't there anything in the open sores community?
You can program them with avrdude and a AVRISPmkII and a breadboard.
Even cheaper, it's possible to wire something up with a PC parallel
port
or some GPIOs on a rPi, but I haven't seen the wiring diagram for the
latter. (Hey, that would be a cool project for CHM!)
-andy
_______________________________________________
Noisebridge-discuss mailing list
Noisebridge-discuss(a)lists.noisebridge.net
https://www.noisebridge.net/mailman/listinfo/noisebridge-discuss
--
.
Patrick Bogen .
...
_______________________________________________
Noisebridge-discuss mailing list
Noisebridge-discuss(a)lists.noisebridge.net
https://www.noisebridge.net/mailman/listinfo/noisebridge-discuss