Re: [sudo-discuss] laser cutter limit switch broken

if you start the raster scan mode too far to the left, the head will overshoot the image and slam into the wall. really stupid but that's just the way it is - - - - Begin automatically generated footer - - - - Web: http://www.adammunich.com [1] Cell: +1-650-452-0554, M-F 10a - 8p PST Note: To protect against computer viruses, e-mail programs may prevent sending or receiving certain types of file attachments. Check your e-mail security settings to determine how attachments are handled. Confidentiality Notice: This electronic mail transmission is intended for the use of the individual or entity to which it is addressed and may contain confidential and/or proprietary information belonging to the sender. If you are not the intended recipient, you are hereby notified that any disclosure, use, copying, distribution, or the taking of any action in reliance on the contents of this information is strictly prohibited. If you have received this transmission in error, please notify the sender immediately by e-mail and delete the original message. Thank you for your cooperation. On Mon, Feb 22, 2016 at 5:38 PM, Morgan Allen <morganrallen(a)gmail.com> wrote: Unless this is recent, it's been that way for a while. Could be what's causing rastering to work though but I cut last week without issue. On Mon, Feb 22, 2016 at 5:15 PM, Jake <jake(a)spaz.org> wrote: i think it will allow you to jog left even if the switch is pressed. i know it's dumb but i think it only looks at the switch when it is homing itself. I could be wrong. if not i can certainly bring a replacement but i'll have to see the old one first. or check those plastic 3d printers from 3dsystems that are kicking around. -jake On Mon, 22 Feb 2016, hol(a)gaskill.com wrote: Hey Adam, I was about to cut a stencil on the laser when I noticed the cut head wa s bumping up against the left side and stalling the motor. I looked and sure enough the steel leaf of the switch was twisted downward. I was a ble to jog the head left while holding the limit switch down so I assume the unit needs to be replaced. Do you know if there are any spares at sudo? I have some from open source hardware that look similar but didn' t want to attempt taking off the rail to get at it and making it worse. Cheers, Hol _______________________________________________ sudo-discuss mailing list sudo-discuss(a)lists.sudoroom.org https://sudoroom.org/lists/listinfo/sudo-discuss [2]