21 Sep
2016
21 Sep
'16
1:34 p.m.
It is, have been using a modified version of mfgr's ABS print settings
in slic3r as always and it shows up as the target temp on the lcd screen
of the printer, just no voltage at the terminal for the heating element.
Installing latest version of Cura now to rule out gcode issues.
On 2016-09-21 12:33, Yardena Cohen wrote:
On Wed, Sep 21, 2016 at 1:07 PM,
<hol(a)gaskill.com> wrote:
Trying here - noticed after I set it up at home
that bead does not
heat. No
voltage on the terminals inside the controller either, is there a
setting
that can be changed via USB but not via the lcd screen menu? I always
just
print from SD, noticed the temperature settings were off to vs. last
time I
used it so will try this route. Nozzle is heating up just fine so
assuming
power is nominal and it's a software issue.
Bed heat is controlled by gcode. Make sure your slicer is set for it.