i flashed a meraki sparky with the script from github, and it said it worked.. but when i try to log into the device either through serial or telnet over ethernet, it doesn't work. Maybe i have the IP address wrong, but for the serial port, i am not getting a full bootup... any ideas? +Ethernet eth0: MAC address 00:18:0a:50:65:3e IP: 192.168.84.1/255.255.255.0, Gateway: 0.0.0.0 Default server: 192.168.84.9 RedBoot(tm) bootstrap and debug environment [ROMRAM] Non-certified release, version v1.3.0 - built 10:45:15, Aug 27 2007 Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc. Board: ap61 RAM: 0x80000000-0x82000000, [0x8003ddd0-0x80fe1000] available FLASH: 0xa8000000 - 0xa87e0000, 128 blocks of 0x00010000 bytes each. == Executing boot script in 2.000 seconds - enter ^C to abort RedBoot> fis load -d linux Image loaded from 0x80041000-0x802fe65c RedBoot> exec Now booting linux kernel: Base address 0x80030000 Entry 0x80041000 Cmdline : [ 0.000000] Linux version 3.3.8 (blogic@Debian-60-squeeze-64-minimal) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #1 Sat Mar 23 17:43:48 UTC 2013 [ 0.000000] gpiochip_add: registered GPIOs 0 to 21 on device: ar2315-gpio [ 0.000000] ar2315-gpio: registered 22 GPIOs [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU revision is: 00019064 (MIPS 4KEc) [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 02000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Zone PFN ranges: [ 0.000000] Normal 0x00000000 -> 0x00002000 [ 0.000000] Movable zone start PFN for each node [ 0.000000] Early memory PFN ranges [ 0.000000] 0: 0x00000000 -> 0x00002000 [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 [ 0.000000] Kernel command line: console=ttyS0,9600 rootfstype=squashfs,jffs2 [ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes) [ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) [ 0.000000] Primary instruction cache 16kB, VIPT, 4-way, linesize 16 bytes. [ 0.0085k kernel code, 3604k reserved, 353k data, 168k init, 0k highmem) [ 0.000000] NR_IRQS:128