it just rests in there, but it has to be pretty precise. On Tue, 29 Aug 2017, hol(a)gaskill.com wrote: > Should be easy to make on the chop saw - how does it secure to the table? > > On 2017-08-26 17:12, Jake wrote: >> i am ordering repair parts for the sudoroom bandsaw, including "bandsaw >> tires" >> (rubber rings that ride on the rollers inside the saw so the blade >> doesn't fall >> off anymore) >> >> but it's still missing the "throat plate" or "table insert" which is a >> square >> plate with a slot cut into it, and it's what holds up the material being >> cut. >> >> it needs to be 1/8" thick and 1.5" square, and then we can use the >> bandsaw to >> cut the slot into it (that's the easy part) >> >> it looks a lot like this, except it should be made of metal ideally: >> https://cdn.instructables.com/FJG/0GY9/H82U8CS5/FJG0GY9H82U8CS5.LARGE.jpg >> >> however if it's made of plastic or acrylic or something not as strong as >> metal, >> it will have to be thicker than 1/8" (except at the edges where it has to >> sit >> on the shelf) >> >> here's a video of someone making one from scratch: >> https://www.youtube.com/watch?v=hsWLQDdWlG0 >> >> can someone make this plate? ideally out of aluminum, i think. >> >> -jake >> _______________________________________________ >> sudo-discuss mailing list >> sudo-discuss(a)lists.sudoroom.org >> https://sudoroom.org/lists/listinfo/sudo-discuss >