Look! https://www.youtube.com/watch?v=hQeeJEpBYsg Someone already asked about using it as 3D printing material on the open manufacturing list and 4ndy said: "If you somehow had an extruder that could use a strip of plastic that buckles under the slightest push... but even then PET is rubbish for FDM/FFF printing due to its high shrinkage compared to PLA. Short answer: no." That's a good point. I wonder if it would be possible to create a print extruder that works for this. It may be that the shrinkage happens before extrusion, such that little or no shrinkage will occur in the print. -- marc/juul _______________________________________________ sudo-discuss mailing list sudo-discuss(a)lists.sudoroom.org https://lists.sudoroom.org/listinfo/sudo-discuss