13 Dec
2013
13 Dec
'13
6:15 p.m.
I have two replacement parts, I will bring them by tonight
On Fri, Dec 13, 2013 at 5:55 PM, Hol Gaskill <hol(a)gaskill.com> wrote:
the transmission cable that goes from the overhead
motor to the spindle
was disconnected last I looked - might have to track it down. good luck!
Dec 13, 2013 05:47:47 PM, yardenack(a)gmail.com wrote:
On Fri, Dec 13, 2013 at 5:35 PM, Jake jake(a)spaz.org> wrote:
_______________________________________________
sudo-discuss mailing list
sudo-discuss(a)lists.sudoroom.org
http://lists.sudoroom.org/listinfo/sudo-discuss
> anyone know how to use the CNC mill? I am
thinking of going to sudo
tonight
> to mill something and it would be easier if
someone can show me how to
do
it,
rather than figuring it out.
or is there a wiki page for the thing?
I know I replied on IRC, but for the benefit of future
readers/archivers/crawlers:
https://sudoroom.org/wiki/CNC
https://sudoroom.org/wiki/O:55
https://imgur.com/a/461VK
_______________________________________________
sudo-discuss mailing list
sudo-discuss(a)lists.sudoroom.org
http://lists.sudoroom.org/listinfo/sudo-discuss