21 Sep
2016
21 Sep
'16
10:07 a.m.
Trying here - noticed after I set it up at home that bead does not heat.
No voltage on the terminals inside the controller either, is there a
setting that can be changed via USB but not via the lcd screen menu? I
always just print from SD, noticed the temperature settings were off to
vs. last time I used it so will try this route. Nozzle is heating up
just fine so assuming power is nominal and it's a software issue.
On 2016-09-21 08:42, robb wrote:
make your daughter happy!
On Tue, Sep 20, 2016 at 10:14 AM, <hol(a)gaskill.com> wrote:
> Working on an LED baby toy for my daughter, getting a bit more complicated than I
thought and not easy to go back and forth between sudo and home. Anyone have imminent
prints to do on the TAZ? Would bring back this weekend at the latest.
> _______________________________________________
> sudo-discuss mailing list
> sudo-discuss(a)lists.sudoroom.org
> https://sudoroom.org/lists/listinfo/sudo-discuss [1]
Links:
------
[1] https://sudoroom.org/lists/listinfo/sudo-discuss