13 Dec
2013
13 Dec
'13
5:55 p.m.
the transmission cable that goes from the overhead motor to the spindle was disconnected
last I looked - might have to track it down. good luck!
Dec 13, 2013 05:47:47 PM, yardenack(a)gmail.com wrote:
On Fri, Dec 13, 2013 at 5:35 PM, Jake jake(a)spaz.org> wrote:
anyone know
how to use the CNC mill? I am thinking of going to sudo tonight
to mill something and it would be easier if someone can show me how to do
it, rather than figuring it out.
or is there a wiki page for the thing?
I know I replied on IRC, but for the benefit of future
readers/archivers/crawlers:
https://sudoroom.org/wiki/CNC
https://sudoroom.org/wiki/O:55
https://imgur.com/a/461VK
_______________________________________________
sudo-discuss mailing list
sudo-discuss(a)lists.sudoroom.org
http://lists.sudoroom.org/listinfo/sudo-discuss