I'm using it a couple times a week these days. I've done a little basic maintenance. The cord from the exhaust fan came loose and that was fixed, I also remounted the exhaust point upward and it seems to work better. One point of work I've been unable to figure out is that it seems the focus is off, certain areas on the bed don't seem to get cut as well as others, it's pretty consistent. I followed the instructions on a youtube video on determining if the mirrors are off, wrapping thermal paper around one mirror, fire test shot, back off, repeat. The idea is the dot should move if the mirror is off but it looked alright. That's as far as I got. Other than that, I think we just need one of those squares for setting the height. On Fri, Dec 4, 2015 at 9:33 AM, Adam <ajm9414(a)rit.edu> wrote: -- -----BEGIN PGP PUBLIC KEY BLOCK----- Version: OpenPGP.js v.1.20121007 Comment: http://openpgpjs.org xsBNBFG3btUBB/9+/WJNOSIuc/praKPaPOweqXV5s7PGRD+HAnNWF/19YAY3 AFtfeoelhhY4sMJoobTaJzcZojznZ1kl/7UuuYCnbJO3Z9kaSMVrVxEZMSLe YmW8Hc4ZsTnl9f05DQFy8ABpAvMLmXJQXh63BbfzjFqNbSWQfLhrubSM2Elq xmN6EsmRyAuEeYlSnal+Di2MlViohpCbbagE2D6AZTUECIamTib6+DuLG4XO b4GGKHR9TXu2qS1VH6hqcvdEz2MDE5OqZzAnBgcF2dvcOdTk9gAOoR1T+qKj IJtg2X0ETbxcPqEXQoXE8VrxN0MLT5JQKTg26+csU4P2w0rEWsUsJombABEB AAHNJU1vcmdhbiBBbGxlbiA8bW9yZ2FucmFsbGVuQGdtYWlsLmNvbT7CwFwE EAECABAFAlG3btwJEG9pFLKaVEfeAAD7hwf+K8LN/kfgi8GTRLiTcuM+hSbm uAeiBY+VaJIQFLzoFlt8A0hBlLNPFNNmUDxdPrMErdHgZ7HtJW/6RANuBTti 5hr3EBguH1GQyK7BbUqJGvaEX4UNRej3uyX3ufXDsIB/3NsKaTyyu+SO0+Hv Cn2DwmlfSXcPhoarx6Turizn/WwgtTN3tqrMWxxiCKWydLH5xYuz+23BLMdc oF/zkbF+7ddFhmyfiFh4Ej9//tsfwPj2cACU3uLTrcwCo7IxUtkrqMF/fhlm LEqjhzDDjq9v7GNWb/5xB2xgTaucJ7/ljuS8nPlZqwCI8NlTgSqC8nyVLyjS yVtOzkItcS0UqyW1Mg== =V/Ia -----END PGP PUBLIC KEY BLOCK-----