29 Feb
2024
29 Feb
'24
12:29 p.m.
https://sudoroom.org/wiki/Printing#Working
Is this 3D printing list on the wiki accurate?
I think afaik there is only one working 3D printer at SudoRoom, and it's on
the mezzanine right?
=============================
Romy Ilano
romy(a)snowyla.com
29 Feb
29 Feb
12:39 p.m.
There are two working 3d printers right now including the Artillery
Sidewinder X1 upstairs and the small one on the main tables, which Simon
used last? We need to update the wikis.
Also the Taz4 works but you need to do it just right and the computer
upstairs got reinstalled :( so we need to set up a slicer for it again.
That one takes 3mm filament, which we have plenty of
-jake
On Thu, Feb 29, 2024, 12:30 Romy Ilano via sudo-discuss <
sudo-discuss(a)sudoroom.org> wrote:
3:44 p.m.
The wiki page for the Artillery Sidewinder upstairs is here
https://sudoroom.org/wiki/Artillery_Sidewinder_X2
The small 3D printer on the main tables is hard to name. According to
Simon:
"I tried Prusa Slicer at first but then I found out that Cura has settings
for the printer built in so I switched to that. In Cura the printer is
called Monoprice Select Mini V2"
I created a wiki page for it here
https://sudoroom.org/wiki/Monoprice_Select_Mini_V2
Here is the wiki for the Taz 4 https://sudoroom.org/wiki/TAZ_4
IMPORTANT: The following start code should be entered in "start Gcode" in
the slicer, to make the extruder work properly: M907 E150
There is another 3D printer next to the laser cutter which was donated, and
has never worked yet, but it's very advanced:
https://sudoroom.org/wiki/Custom_3D_Printer
If someone wants to update the wiki for the 3D Printing page, that would be
great: https://sudoroom.org/wiki/Printing#3D_printing
-jake
On Thu, Feb 29, 2024, 12:30 Romy Ilano via sudo-discuss <
399
days inactive
399
days old
2 comments
2 participants
participants (2)
-
Jake Watters -
Romy Ilano