3 Aug
2014
3 Aug
'14
3:25 p.m.
was talking to david about trying to get some HVAC ducting at urban ore.
i bet they have a lot of big sections just sitting there needing a
little work and blowing the air up to one of the existing exhaust fans
in the ceiling. in the interim the cart (rolling chair w/ welder sitting
on it) could be rolled to the utility room and the box fan set at the
door for exhaust. thanks for remembering safety too, flux core wire is
almost as dirty burning as stick welding electrodes. What I'd really
like to do is find a longer sheath so the welding tip can be mounted on
an x-y table or of course arm. i didn't note the nature of all the parts
that came with it but did that arm come with its own welding power
supply?
On 2014-08-03 13:40, Jake wrote:
Hi Hol,
that's a really neat welder! If you want to tune it up and make it work better, you
might want to replace the tube that the wire gets pushed through. When it develops
friction, the drive wheel can't push the wire through reliably.
Fortunately the tube can be replaced with bicycle brake cable! Just get some of the good
stuff (teflon lined) from a bike shop, and razor off the rubber coating so it fits in
place of the original hose. The welder will work better than new!
As for the flux-core wire, it is very dangerous to use that indoors, because the flux is
for preventing oxidation - and our lungs need to oxidize! So it should never be used
indoors (and using it outdoors will require a shield so passersby don't see the arc)
At some point we should talk about making a ventilated corner of sudoroom, where welding
and other fume-producing tasks can take place. Hell, maybe the Robot will be welding by
then.
http://www.youtube.com/watch?v=osErRS4m4S8#t=55 [1]
-jake
Hol wrote:
i brought in a small wirefeed welder. it uses fluxcore wire so doesn't
require a shield gas, just turn it on, clamp the ground to your work,
point and click. the wheel that drives the wire from the box through the
cable to the gun doesn't have very good traction, so check there if the
wire doesn't feed. the welder uses 17 amps so only use directly plugged
into an outlet (!!!)
bring steel! the antique saw actually works really well for cutting
stock down to size
Links:
------
[1] http://www.youtube.com/watch?v=osErRS4m4S8#t=55