normally open or normally closed? On 2016-02-22 17:10, Adam wrote: There might be a limit switch kicking around, but I haven't been to sudo in a long while so I'm not sure where. Jake probably has one On 22 Feb 2016 5:09 pm, <hol(a)gaskill.com> wrote: > > Hey Adam, > > I was about to cut a stencil on the laser when I noticed the cut head was bumping up against the left side and stalling the motor. I looked and sure enough the steel leaf of the switch was twisted downward. I was able to jog the head left while holding the limit switch down so I assume the unit needs to be replaced. Do you know if there are any spares at sudo? I have some from open source hardware that look similar but didn't want to attempt taking off the rail to get at it and making it worse. > > Cheers, > > Hol > >